Tray 2 Shaft
1 Remove the Top Cover (page 6-12), Left and Right Side Covers (page 6-23), Pickup Gear Assembly (page 6-36), and Paper Handling PCA (page 6-31). Remove the spring from the gear on the left side of the shaft. Align the solenoid arm (B) (see Figure 6-43) with the gap in the gear (on the left side of the printer). Press the release tabs (A) outward, and slide the gear off the shaft. Remove the bushing on the right side of the shaft by lifting the release tab and sliding it off the shaft. Slide the shaft to the right, then angle it out of the chassis.
